HOT TUB COVERS

Order it the way you want it.

CUSTOMIZE YOUR
HOT TUB COVER

DOWNLOAD YOUR ORDER FORM

You can easily request a custom hot tub cover for any model by following the instructions provided below.

1
Download the Order Form
Download
2
Measure hot tub
See how to measure your hot tub
3
Choose your cover colour
See available colours
4
Send us your order form
retail@budsspas.com

Measuring your hot tub

How-to-measure-your-Hot-Tub-Cover-diagram

How-to-measure-your-Hot-Tub-Cover-rounded-edges

1 Measure lip to lip. Regardless of the shape your spa, you should measure from lip to lip, or the outside dimension of the acrylic which is the same as lip to lip. After you have a lip to lip measurement you may add up to 1" on both length and width. This will give you a 1/2" of play all around your spa cover.
2 Measure the skirt. The skirt is the flap that hangs from the bottom of your cover. The skirt protects the spa surface and aids in heat retention, if not measured correctly can cause some problems because if it is too long it will bunch and push your spa cover up. If you have a wood rail as in the picture above measure from the top of the wood rail to the top of your spa acrylic. If anything you want to be a little short rather than long so the skirt does not bunch. If you do not have a wood rail then you want to measure from the top of the spa to the bottom of the spa lip and add 1/2".
3 Measure the radius. This is how you measure a curved edge on your hot tub, and it's the step that makes everyone worried. As the lower diagram on the left shows, the easiest way to measure a radius, which is with a carpenter square. The dimension needed is from the start of the bend to the imaginary point of the square if the tub was actually square. Rule of thumb is smaller is safer than larger. The smaller the radius the more square the corners of the hot tub cover. Your hot tub cover radius will always be an even number. To measure radius "C": extend straight lines indicated in red by laying straight edges against the sides of the hot tub. Measure from point "Y" to point "Z".

How to measure different shapes

Square Cover

Rectangular Cover

Square or rectangular cover with rounded corners

Round cover

Octagonal cover (8 equal-length sides)

Ellipse or Special Shapes

Be sure to identify strap and handle locations, or any other features of your cover. Identifying strap locations will ensure your straps line up with the receiving end that is screwed to your spa cabinet. Measure the distance from the corner of the cover and mark on the image at the bottom of the form. The same can be done for the handles on the cover if you are concerned about placement. Does your cover attach to a cover lifter, have cut outs for speakers, have reinforced plates? Please let us know.